Home Page | Owners Registry | Discussion Forums | ProwlerMall | Event Scrapbooks | About |
Prowler Products By Gary | Tom Mills / Jefferson Auto |
Click here to return to the Prowler Online Board Main Page |
ProwlerOnline, Plymouth/Chrysler Prowler Discussion Forum
Technical Questions & Answers picture of the center cap fracture
|
Bottom of Page | next newest topic | next oldest topic |
Author | Topic: picture of the center cap fracture |
CatDude POA Site Supporter Prowler Avatar Master From:Charlottesville, Va |
posted 02-19-2002 09:50 PM
My car came with a broken center cap. Two of the plastic stems were broken. For the benefit of those who do not have broken center caps, here is a picture to show where they break. A third stem began to fracture and this picture very clearly shows the fracture on the stem. I believe that they broke while being installed or after installation, because the broken pieces were still inside the cap when I took it off the wheel.
Click on the hyperlink below to see a higher res version of the picture. http://www.damonc.com/fracture.jpg ------------------ This message has been edited by VirginiaCatDude on 02-19-2002 at 09:51 PM |
Ray unregistered Admin Use |
posted 02-19-2002 10:10 PM
Damn cheap plastic and stupid design!! |
ALLEY CAT POA Lifetime Site Supporter Prowler Junkie From:mesa, az, USA |
posted 02-22-2002 07:23 AM
VDC - when you get the new caps, please read the post by MadMax on his MadMax Hot Glue Treatment System, to prevent future breakage. His process carries the Alley Cat Stamp of Approval. ------------------ |
CatDude POA Site Supporter Prowler Avatar Master From:Charlottesville, Va |
posted 02-22-2002 08:28 PM
Right... for anyone who has not seen MadMax Hot Glue treatment, just click here: I haven't tried it myself yet, but I plan to. ------------------ This message has been edited by VirginiaCatDude on 02-22-2002 at 08:30 PM |
dpena POA Site Supporter Administrating Kat Visit Dan's Prowler Excitement Personal ScrapBook From:San Jose Ca Santa Clara |
posted 02-22-2002 08:52 PM
Here is mine.. Later.. ------------------ |
All times are CT (US) Top of Page Previous Page | Return to Technical Questions & Answers next newest topic | next oldest topic |
All material contained herein, Copyright 2000 - 2012 ProwlerOnline.com
E-Innovations, LP