Home Page Owners Registry Discussion Forums ProwlerMall Event Scrapbooks About

Click here to return to the Prowler Online Board Main Page 		  ProwlerOnline, Plymouth/Chrysler Prowler Discussion Forum
  General Prowler Discussion
  Top 10 Modifications? (Page 2)

Post New Topic  Post A Reply
edit profile | register | preferences | faq | search

   Bottom of Page
This topic is 2 pages long:   1  2  		next newest topic | next oldest topic
Author Topic:   Top 10 Modifications?
GRROWL


POA Site Supporter
Prowler Junkie

From:Herndon, VA
Registered: Feb 2002
Admin Use

posted 01-31-2003 05:12 PM     Click Here to See the Profile for GRROWL     send a private message to GRROWL   Edit/Delete Message   Reply w/Quote   Search for more posts by GRROWL
quote:
Originally posted by GPS John:
9. Kitty Decal Cover-up for Airbag-warning Sticker.

Hey Grrrowl, do you have the source for the airbag
decal cover? Best solution I've seen yet. Looks good!

Excuse the form of the following, it was actually a reply to a private Email:

Actually, they're so inexpensive they're not worth making
yourself - take a look at discussion at:
http://www.prowleronline.com/ubb/Forum1/HTML/006801.html

You can order them from:

www.Streamlinedesign.com

Worthwhile surfing the whole site (pinstriping, bullet
holes, etc.) but here's the direct link to the Prowler
section:
http://www.streamlinedesign.com/prowler/

Then click on "Interior" or "Vinyl Logos" (this is the
section where I found the decals for the mudflaps listed as item #1.5..

Good luck. Welcome to POA. Post often.

-GRROWL

Randy Cobb




POA Site Supporter
Prowler Junkie

From:Greensboro, NC
Registered: Jul 2002
Admin Use

posted 02-01-2003 05:43 PM     Click Here to See the Profile for Randy Cobb     send a private message to Randy Cobb   Edit/Delete Message   Reply w/Quote   Search for more posts by Randy Cobb
I hope a reply to the airbag decal is appropriate under this section.

I actually removed my airbag warning decals from the visors.

It took some time and care, but they will peel off. I didn't use any solution at all. I just CAREFULLY picked at one corner to get it started and GENTLY and SLOWLY peeled off in small pieces. I'd pull a little area (about the size of a quarter) at a time making sure the vinyl didn't become too pliable.

Visors look so much better now.

------------------

GRROWL


POA Site Supporter
Prowler Junkie

From:Herndon, VA
Registered: Feb 2002
Admin Use

posted 02-01-2003 06:38 PM     Click Here to See the Profile for GRROWL     send a private message to GRROWL   Edit/Delete Message   Reply w/Quote   Search for more posts by GRROWL
quote:
Originally posted by Randy Cobb:
I hope a reply to the airbag decal is appropriate under this section.

Hey Randy,

I originally posted it, and it's fine with me.

-GRROWL

GRROWL


POA Site Supporter
Prowler Junkie

From:Herndon, VA
Registered: Feb 2002
Admin Use

posted 02-01-2003 07:18 PM     Click Here to See the Profile for GRROWL     send a private message to GRROWL   Edit/Delete Message   Reply w/Quote   Search for more posts by GRROWL
quote:
Originally posted by ed monahan:
I had one made by my local graphics guy. I think it is a definite must. I had mine made in Red to match the paint. It is actually a hair darker on the paint but not very noticable.

Ed,

Does he do the "Prowler" cutout like the DekProTek? What I'm thinking is matte black with the cutout in the area between the hardtop and softtop contact areas. It would be visible with the softtop up or down, wouldn't be visible with the hardtop.

What do you think?

Thanks.

-GRROWL

ed monahan





POA Lifetime Site Supporter
Prowler Junkie
Personal ScrapBook

From:Cincinnati, Oh, USA
Registered: Jul 2000
Admin Use

posted 02-01-2003 11:29 PM     Click Here to See the Profile for ed monahan     send a private message to ed monahan   Edit/Delete Message   Reply w/Quote   Search for more posts by ed monahan
Grrowl, I did not have the cutout put on mine but I am sure that they can do that.
ed monahan





POA Lifetime Site Supporter
Prowler Junkie
Personal ScrapBook

From:Cincinnati, Oh, USA
Registered: Jul 2000
Admin Use

posted 02-02-2003 01:19 AM     Click Here to See the Profile for ed monahan     send a private message to ed monahan   Edit/Delete Message   Reply w/Quote   Search for more posts by ed monahan
quote:
Originally posted by Chromer:
The top modification is to a certain individuals reputation....maybe I'm out of line here...but I'm a little stunned by the recent post and the business as usual attitude?..

Chromer, you lost me on this one. Did someone slam the hardtop? The hardtop has a different configuration than the ragtop and both tops will make marks in the paint. It is not due to a defect in either top. The tops move a little and thus the scratches in the paint. The original Deck-Pro and others do not extend far enough onto the trunk surface to protect the trunk lid with a hardtop, simply due to size.

Black Tie 161


POA Site Supporter
Prowler Junkie

From:MD, USA
Registered: Jul 2002
Admin Use

posted 02-04-2003 07:58 AM     Click Here to See the Profile for Black Tie 161     send a private message to Black Tie 161   Edit/Delete Message   Reply w/Quote   Search for more posts by Black Tie 161
10- airbag warning sticker covers
9- silver vinyl kitty on steering wheel.
8- Prowler logo on door sills
7- black cat logo below trunk
6- 303 top protectant treatment
5- mudflaps front and rear!
4- MTD EGR By-Pass
3- removed baffles from tailpipes
2- Real Rod Trans cooler cover.
AND NUMBER ONE: (drumroll please) MTD 2.2 INTAKE SYSTEM
Marty Usher



POA Site Supporter
Prowler Junkie

From:San Antonio, Texas, United States
Registered: Jun 2001
Admin Use

posted 02-04-2003 08:20 AM     Click Here to See the Profile for Marty Usher     send a private message to Marty Usher   Edit/Delete Message   Reply w/Quote   Search for more posts by Marty Usher
here are my second ten mods:

11. remove sun visors
12. remove windshield wipers
13. RealRod chrome sill protectors
14. chrome tranny cover
15. larger chrome tach
16. stainless engine braces
17. chrome radiator brace
18. engine Shimmers
19. Dunlop tires
20. Top down when ever possible!

Randy Cobb




POA Site Supporter
Prowler Junkie

From:Greensboro, NC
Registered: Jul 2002
Admin Use

posted 02-04-2003 08:20 AM     Click Here to See the Profile for Randy Cobb     send a private message to Randy Cobb   Edit/Delete Message   Reply w/Quote   Search for more posts by Randy Cobb
CT:
Notice a trend? It seems that everyone has their individual preferences EXCEPT that almost everyone has flaps and ceramic pads on or at the top of their list.

Randy

------------------

GRROWL


POA Site Supporter
Prowler Junkie

From:Herndon, VA
Registered: Feb 2002
Admin Use

posted 03-27-2005 08:05 AM     Click Here to See the Profile for GRROWL     send a private message to GRROWL   Edit/Delete Message   Reply w/Quote   Search for more posts by GRROWL
This thread has been dormant for too long and needs to be reborn now that it's Spring. Lots of great ideas here.

-GRROWL

BeWare





POA Site Supporter
Prowler Junkie

From:Acworth , Georgia , USA
Registered: Jul 2000
Admin Use

posted 03-27-2005 09:20 AM     Click Here to See the Profile for BeWare     send a private message to BeWare   Edit/Delete Message   Reply w/Quote   Search for more posts by BeWare
My top 10 list has changed (not in order)

1) Front Flaps (Front a must, rear optional)
2) Ceramic front pads
3) Performance Exhaust (you pick)
4) Custom Paint Work
5) Real Rod Grille
6) Transmission Cooler Cover
7) Shimmers
8) Gears
9) Remove Front Bumpers
10)Two Tone Interior

CJ





POA Lifetime Site Supporter
Prowler Junkie
Personal ScrapBook

From:Rochester Hills, MI USA
Registered: Jul 2000
Admin Use

posted 03-27-2005 12:50 PM     Click Here to See the Profile for CJ     send a private message to CJ   Edit/Delete Message   Reply w/Quote   Search for more posts by CJ
I don't know if I could list 10 modifications that I would recommend.....

1. Front and rear mud guards
2. Ceramic brakes
3. Mopar/Borla Exhaust system
4. Painted bumpers
5. Chrome grille
6. Personalized sill plates from Real Rod
7. Hardtop

DETECTIVE ON THE PROWL


POA Site Supporter
Prowler Junkie

From:Calabasas, Ca 91302
Registered: Dec 2004
Admin Use

posted 03-27-2005 04:07 PM     Click Here to See the Profile for DETECTIVE ON THE PROWL     send a private message to DETECTIVE ON THE PROWL   Edit/Delete Message   Reply w/Quote   Search for more posts by DETECTIVE ON THE PROWL
Can anyone explain what the $10.00 grill mod is ? I could save a lot of money before my next trip to Gary's LOL Thanks

------------------

pumpkin


POA Site Supporter
Prowler Junkie
Visit Waleke's World
Personal ScrapBook

From:Las Cruces, NM, USA
Registered: Dec 2001
Admin Use

posted 03-27-2005 04:19 PM     Click Here to See the Profile for pumpkin     send a private message to pumpkin   Edit/Delete Message   Reply w/Quote   Search for more posts by pumpkin
quote:
Originally posted by DETECTIVE ON THE PROWL:
Can anyone explain what the $10.00 grill mod is ? I could save a lot of money before my next trip to Gary's LOL Thanks


Chrome door molding from Pep Boys.


This topic is 2 pages long:   1  2 

All times are CT (US)  Top of Page  Previous Page

 Return to General Prowler Discussion  next newest topic | next oldest topic



Administrative Options: Close Topic |Make Sticky | Archive/Move | Delete Topic
Post New Topic  Post A Reply
Hop to:

Contact Us | Prowler Online Homepage

All material contained herein, Copyright 2000 - 2012 ProwlerOnline.com
E-Innovations, LP

POA Terms of Service