 Click here to return to the Prowler Online Board Main Page |
 ProwlerOnline, Plymouth/Chrysler Prowler Discussion Forum
 General Prowler Discussion
 LED tail lights, what is best?
|
| Bottom of Page | next newest topic | next oldest topic |
| Author | Topic: LED tail lights, what is best? |
TNtraveler  POA Site Supporter Prowler Junkie From:Bethpage, TN, USA |
posted 07-07-2020 06:56 PM
    
Hi O Great and Wise Ones, Best bulbs for use in tail lights to LED. Been almost rear ended a few times, want to be seen. THANKS |
stevedymo    POA Site Supporter Prowler Junkie Personal ScrapBook From:Brick, NJ, USA |
posted 07-08-2020 07:06 AM
Without seeing the car, I would have to ask if the tail light lens are tinted? If they are then get the tint off and go back to original look. The tint might look cool but puts you at risk of getting rear ended. I was behind a Prowler on a cruise with tinted tail lights and could not tell when they were braking. I had to watch the third light on the deck lid. Alerted them to this and the tint was removed for greater visibility. |
LSK   POA Site Supporter Prowler Junkie From:Asheville, North Carolina, United States |
posted 07-08-2020 08:10 AM
I added a 3rd brake light flasher in 2015. It's set up to flash 3 short flashes then on for 3.5 seconds then repeat until you let off the brakes. It definitely get the attention of the driver behind you. I hooked it into the wiring under the trunk carpet at the trunk lid hinges. The module is small and you don't even notice it under the carpet. http://www.amazon.com/gp/product/B001F85OUM/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&psc=1 |
pete7383  POA Site Supporter Prowler Junkie From:SCOTTSDALE, AZ, United States |
posted 07-08-2020 03:18 PM
Was the third light flasher plug and play or did it require striping and wiring? |
|
LSK POA Site Supporter Prowler Junkie From:Asheville, North Carolina, United States |
posted 07-08-2020 04:03 PM
quote: You have to cut and wire it to the existing 3rd brake light wiring. The flasher comes with a wiring diagram as the way it flashes depends on the wires you hook up. I found the wiring diagram in my Prowler manual for the 3rd brake light to determine what colors I needed to hook to. I used male and female crimp connectors and installed them so I could unplug the flasher and reconnect the 3rd brake light if the flasher failed. |
All times are CT (US) Top of Page Previous Page | Return to General Prowler Discussion next newest topic | next oldest topic |
  |
|
Contact Us | Prowler Online Homepage
All material contained herein, Copyright 2000 - 2020
