Home Page | Owners Registry | Discussion Forums | ProwlerMall | Event Scrapbooks | About |
Bottom of Page | next newest topic | next oldest topic |
Author | Topic: Tire pressure sensors faulty |
erich POA Site Supporter Prowler Junkie From:Macomb, MI USA |
posted 05-22-2017 11:27 AM
Still on original run-flats with 8k miles. Unable to shut off tire pressure warning light and chime. Local dealer checked to see which tire was involved and test showed all 4 were bad, which he claims is impossible. Won't touch because it might mess up computer. Any ideas or input will be much appreciated. |
stevedymo POA Site Supporter Prowler Junkie Personal ScrapBook From:Brick, NJ, USA |
posted 05-22-2017 12:32 PM
What is the Air Pressure reading on each tire? Has the car been sitting and this was the first time taking it out? |
erich POA Site Supporter Prowler Junkie From:Macomb, MI USA |
posted 05-22-2017 12:41 PM
Tire pressure exactly as specified, 28 psi front & 32 rear. This is ongoing problem from a year ago. Doesn't matter whether driving short or long distances. |
stevedymo POA Site Supporter Prowler Junkie Personal ScrapBook From:Brick, NJ, USA |
posted 05-22-2017 12:49 PM
It is possible then that the battery in each sensors is WEAK or DEAD. One last thing I would try is disconnect the NEG cable for 15 sec and reattach, start the car and drive it above 20 MPH and see if that clears up the problem. If that doesn't work, pull the dash and disconnect the module and remove the Low Tire lite bulb until you get new sensors. |
robin POA Site Supporter Prowler Junkie From:St Thomas Ontario Canada |
posted 05-22-2017 01:30 PM
My opinion would be before you drive the car any distance!! Take off the run flats they are old and dangerous. Secondly what is your opinion on keeping the sensor? You can buy a replacement kit cost 600 dollars plug and play. If you are iPhone savvy you could go after market. You can use the search feature to explore this topic Tires and sensors. robin |
robin POA Site Supporter Prowler Junkie From:St Thomas Ontario Canada |
posted 05-22-2017 01:41 PM
If you don't want to use the TPMS and the light or bell sound comes on . Just Pull the Dash back and unplug the light and sending unit .Check Tire pressure time to time and Problem solved .. cheapest option tire info just incase you want to drive your car .. This message has been edited by robin on 05-22-2017 at 01:44 PM |
CJ POA Lifetime Site Supporter Prowler Junkie Personal ScrapBook From:Rochester Hills, MI USA |
posted 05-22-2017 01:50 PM
Erich.....Who was your dealer? Golling Chrysler Dodge Jeep on Telegraph in Bloomfield Hills, is our dealer of choice. They have three Prowler techs and we have used them before. The GM at Golling is Joe Ellsasser. He belongs to POA also. I just called him and he said if you want, call them to set up an appointment. Joe also said they fixed his issue. I'm sure they probably can help. The tech names are Brian, Gerard and Rudd. If you call, ask for Veronica and tell her you are with the Prowler club along with Joe. She will get you to one of the Prowler techs. Within the hour, Joe is going to let her know that you might be calling so she can help you. They are great people at Golling. Golling's number is 248.334.3600 This message has been edited by CJ on 05-22-2017 at 01:52 PM |
erich POA Site Supporter Prowler Junkie From:Macomb, MI USA |
posted 05-22-2017 03:03 PM
Thanks to everyone for your suggestions and help. I feel my best bet will be to go with Golling and let the true experts take a look. I'm up north right now with friends. Will at least touch base with Veronica to get the ball rolling. Thanks, CJ, for all the detailed info... |
robin POA Site Supporter Prowler Junkie From:St Thomas Ontario Canada |
posted 05-22-2017 06:26 PM
Erich welcome to POA . I Wish you the best of luck with your car. One thing to keep in mind is that our cars are twenty years old this year. Although they may have a prowler tech at that particular dealer. They will still face the same problems many face on this web site locating parts . They don't stock prowler TPMS at the dealer. You will come to value the experience and knowledge that many members here have and share. Dealers are expensive. You can solve a lot of your problems by doing a search and reaching out to member with years of experience. robin |
CJ POA Lifetime Site Supporter Prowler Junkie Personal ScrapBook From:Rochester Hills, MI USA |
posted 05-22-2017 07:53 PM
Erich......you are welcome! I hope that they will be able to resolve your issue. I have a lot of faith in them. |
Silverado Prowler Enthusiast From:USA, Brooklyn |
posted 05-22-2017 08:20 PM
Has anyone tried replacing the batteries on the TPMS? video http://www.youtube.com/watch?v=-phXgo9tJ-Q Notice the Jelly like substance on the same as in the ECM Tomcal is doing |
Largent POA Site Supporter Prowler Junkie From:Saugus, CA, USA |
posted 05-23-2017 08:03 AM
Yikes - still on the original 20 year old tires - this is very dangerous! Change those tires today! Read this post for some tire info and a link to TPMS info.... |
CAT-A-TONIC POA Site Supporter Prowler Junkie From:SANTA CLARA,CA. |
posted 05-23-2017 11:01 AM
I don't mean to be repetitive regarding this topic but if I'm reading this right as far as the tire sensors are concerned, is this another area that we as Prowler owners are once again on our own? Does Chrysler still have these available but are cost prohibitive or just not available period? If there is after market sensors available and are they calibrate-able with our cars system? Has anybody cut the bottom off of one of the stock sensors and taken a peak inside? Possible battery replacement? |
padroo POA Site Supporter Prowler Junkie From:Chesterton, IN, USA |
posted 05-23-2017 11:20 AM
It's been a whole but there are many options for TPMS sensors in past post. I installed a 2002 module and installed Doreman Direct-Fit Sensors.
http://www.amazon.com/Dorman-974-002-Chrysler-Mitsubishi-Pressure/dp/B001UCCNI4 This only works if you upgrade to the 2002 module under the dash cover, 2 screws and a plug, easy swap. This is the module part number for a 2002 module. #4815 227AD, I bought a used one and saved some money. To my knowledge modules are not know to go bad, TPMS sensors have a battery inside and they go bad over time. This upgrade will future proof your system because the sensors are still being made. This message has been edited by padroo on 05-23-2017 at 11:36 AM |
robin POA Site Supporter Prowler Junkie From:St Thomas Ontario Canada |
posted 05-23-2017 11:30 AM
CAT-A-TONIC To answer your question about take (apart a sensor). Maybe Golling Chrysler Dodge Jeep has parts the rest of use don't have access to. This message has been edited by robin on 05-23-2017 at 11:31 AM |
robin POA Site Supporter Prowler Junkie From:St Thomas Ontario Canada |
posted 05-23-2017 11:55 AM
To be honest I'm frustrated that erich is being directed to a another dealer. I'm not sure if you (erich) had to pay diagnostic fees. But to me they were bang on except for damaging your computer. Your TPMS is old any finished. Same as your tires unless you just want a trailer queen. Not to start a war CJ forgive me.. Anyway good luck with your car I hope you find the answers to this issue. robin |
erich POA Site Supporter Prowler Junkie From:Macomb, MI USA |
posted 05-23-2017 04:28 PM
I really do appreciate all the input, advice, care & concern shown by everyone and, I too, don't want to start a war. First off, I'm not mechanically inclined, and at this stage of my life that's not about to change, so must defer to someone who is. I had an order for the TPMS placed with local Mopar Parts Dept (Parkway Chrysler) & after searching the entire nation for over 8 mos finally located "1" in New York. I first took it to a Goodyear tire dealer who told me it had to be programmed and recommended Sterling Hts Dodge. At no cost to me, they took their diagnostic machine & checked each tire to see which was bad & all 4 showed bad. I was told that was pretty much impossible so I left, having nothing done. I did pay in excess of $150(not quite sure as I'm away from my records) & I don't even know if this is a new part or an old return just sitting on the shelf collecting dust somewhere in NY. So, looks like we're on our own on this part too. |
robin POA Site Supporter Prowler Junkie From:St Thomas Ontario Canada |
posted 05-23-2017 05:07 PM
You're not starting a war erich. Just my frustration sorry to you and CJ. |
CJ POA Lifetime Site Supporter Prowler Junkie Personal ScrapBook From:Rochester Hills, MI USA |
posted 05-23-2017 07:25 PM
quote: Robin......not starting a war but...... I've been on this site since 2000 and other Prowler clubs before that. I ran the Plymouth Prowler Road show for Chrysler....my husband was on Team Prowler. That being said, I am not unfamiliar with Prowler. I was a used as a liaison between some of the Prowler Team members who read the site but was not allowed to post. So, they sent it to me and I posted for them. Do I know everything? No. However, we know a lot of people that can help. Bob has done a lot of that for owners. Not everyone has the same issues and resolutions. It's great that everyone can talk about their experiences with their Prowlers and that certainly gives others options to look for answers. I did not tell Erich where he HAD to go or what to do. He doesn't live that far from me. We have not met yet, but I wouldn't stay silent if we could help. There aren't as many Prowler Techs as there used to be. It is his choice as to what he wants to do and I won't be offended if he doesn't seek the Techs at Golling.
|
robin POA Site Supporter Prowler Junkie From:St Thomas Ontario Canada |
posted 05-23-2017 08:39 PM
Touché |
All times are CT (US) Top of Page Previous Page | Return to General Prowler Discussion next newest topic | next oldest topic |
All material contained herein, Copyright 2000 - 2012 ProwlerOnline.com
E-Innovations, LP