posted 08-23-2007 02:03 AM                  

Just wondering the status of the Mudflap bracket? I have send you a few pm's.

Thanks,

Joseph

posted 09-05-2007 06:08 PM                  

Joseph

posted 04-14-2008 12:41 PM                  

Just sent you a PM from England!!

posted 04-15-2008 11:37 PM                  

I have Bob Millers factory new mudflap bracket and have had it for the last couple of months. I keep promising to make some more and I will but I just have too many things going on right now to get to it.
I made my first prototype plate and am happy with it but I need to make some tooling to dimple the area where the bolt penetrates the plate for a flush rear fit.

After the initial requests for these parts, there hasn't appeared to be much need for them so I haven't pushed very hard to get them done. I don't want to make anything other than a near perfect replica of the factory part if I'm going to make them. They can be quickly and easily made if the owners don't care about the factory appearance but to make them correctly I will need to make some special tooling.

I'll try to get some made soon but my plate is very full right now with my new building construction, new computer system, point of sale programs and my business relocation plans. Heck, I haven't even had my Prowler or my roadster out of the garage in over 2 months. It's now 9:30 PM and I'm still at work. Enough of my excuses. I'll work on them soon.

posted 04-19-2008 02:26 PM                  

quote:

---

Originally posted by Joseph Mark:
Still waiting for response Jeff?

Joseph

---

It's my fault.
I have Bob Millers factory new mudflap bracket and have had it for the last couple of months. I keep promising to make some more and I will but I just have too many things going on right now to get to it.
I made my first prototype plate and am happy with it but I need to make some tooling to dimple the area where the bolt penetrates the plate for a flush rear fit.

After the initial requests for these parts, there hasn't appeared to be much need for them so I haven't pushed very hard to get them done. I don't want to make anything other than a near perfect replica of the factory part if I'm going to make them. They can be quickly and easily made if the owners don't care about the factory appearance but to make them correctly I will need to make some special tooling.