Home Page | Owners Registry | Discussion Forums | ProwlerMall | Event Scrapbooks | About |
Prowler-Parts.Com | Prowler Products By Gary | Tom Mills / Jefferson Auto | Prowler-Products Trunks |
Bottom of Page | next newest topic | next oldest topic |
Author | Topic: T.C.Module resetting question. |
Starpilot Prowler Enthusiast From:NJ, United States |
posted 04-27-2018 11:00 AM
Using a Actron CP9690... Have codes P0700 (45) and P0731 (mod41) Is a good diagnostic reader needed to properly reset the Transmission Control Module. I have a car that just sits.... and now has shifts like you popped a clutch on a manual transmission, the wheels will actually chirp. It will go through all the gears but obviously is most dramatic from first to second. I replaced the sensors just because that was easy, no difference. Now I want to reset the TCM as step two. I've removed the battery before to no avail. I now actually have it out as it needs replacement... Once I replace it, what's the process of resetting the TCM. (Car sits in a temped garage 55 to 75 degrees.) It's worth noting, I have two prowlers. So I know what normal shifting is like. This one was normal. ------------------ This message has been edited by Starpilot on 04-27-2018 at 01:18 PM |
robin POA Site Supporter Prowler Junkie From:St Thomas Ontario Canada |
posted 04-27-2018 11:53 AM
read these search topic.. hope they help. http://www.prowleronline.com/cgi-bin/search.cgi?action=simplesearch&SearchIn=ALL&ForumChoice=ALL&SearchTerms=car+shifting+into+second+&BooleanAND=YES&SearchDate=ALL&SearchUser=&Exa ctName=&File=temp-2458236-115027-47t4.cgi&Total=4&StartAt=A:000002 |
Tomcal POA Site Supporter Prowler Junkie From:Commack, NY, USA |
posted 04-27-2018 03:45 PM
Please post in only one area, you'll get better results. P0700 is a catch all code for trans shifting malfunction. P0731 code is probably caused by a bad/sticking "Solenoid Control Pack". But before replacing Pack, I would remove TCM connector and reinstall. Do this a few times to clean connections. Same to connector on transmission end. This Pack receives signals from TCM to electrical operate solenoids that route fluid controlling shift functions. Solenoid Pack is accessible after removing trans oil pan and valve body. You can do this yourself if your mechanically inclined and patient. You may or may not have to remove rear cross member under trans oil pan. This video is for our transmission, 42LE, although car shown is Intrepid; In car removal: Out of car removal for reference: This message has been edited by Tomcal on 04-27-2018 at 03:51 PM |
padroo POA Site Supporter Prowler Junkie From:Chesterton, IN, USA |
posted 04-27-2018 04:54 PM
Has this car ever had the transmission fluid changed? How many miles on it? This message has been edited by padroo on 04-27-2018 at 04:54 PM |
Starpilot Prowler Enthusiast From:NJ, United States |
posted 04-27-2018 05:10 PM
I think less than 3,000 miles on it.. and trans fluid has not been changed. |
All times are CT (US) Top of Page Previous Page | Return to Prowler Performance/Appearance Discussion next newest topic | next oldest topic |
All material contained herein, Copyright 2000 - 2012 ProwlerOnline.com
E-Innovations, LP