posted 03-02-2003 01:21 PM                  

If you have a trained Prowler Tech, they probably have the special tools required to maintain your Prowler. If you perform your own maintenance, you should purchase a maintenance manual which will tell you when any special tools are needed.

Welcome and hope the picture means you're driving a Mulholland.

posted 03-02-2003 02:58 PM                  

Here is a description of the contents:

Miller Special Tools
Prowler Essential Tool Kit
Number: 6999
Includes the following tools:
6998 Remover - This tool is used to remove the ball joint studs from the front steering knuckle
8106 Adpater, Torque Wrench - Use this torque wrench adapter to adjust the front upper control arem cam on Prowler Vehicles
8182 rRmover - This special tool is used to remove the parking brake cable from the console flange during servicing procedures on the new Prowler.
8182 Remover - This special tool is used to remove the parking brake cable from console flange during servicing procedures on the Prowler.
8183 Remover - Use this new tool to remove the rear lower control arm ball joint stud from the knuckle
8185 Adapters, Power Steering - Thse special adapters asre used with the 6815 Power Steering Analyzer to connect at the steering gear for diagnostics.
8187 Adapter - This new adapter is used with the C-4007-A Brake Gauge set to connect at the proporiioning valve for pressure diagnostics
8190 Remover/Installer - This tool is used to service supsnsion bushings on the Prowler
8191 Holder, Sprocket - Use this tool to hold the crankshaft sprocket on 3.5L engines in the Prowler during serviing procedures
8192 Magnet - This speically designed magnet is used with the DRBIII to reset the sending unit for tire pressure gauges on Prowler wheels.
8193 Disconnect Tool - This special tool is used to disconnect the 3/8" transaxle cooling lines in Prowler vehicles