Home Page | Owners Registry | Discussion Forums | ProwlerMall | Event Scrapbooks | About |
Click here to return to the Prowler Online Board Main Page Topic Closed |
ProwlerOnline, Plymouth/Chrysler Prowler Discussion Forum
General Prowler Discussion FMB Trailer Stand Improvement Information
|
Bottom of Page | next newest topic | next oldest topic |
Author | Topic: FMB Trailer Stand Improvement Information |
Larry Lord Prowler Junkie Personal ScrapBook From:Colton, CA |
posted 06-12-2002 01:26 AM
After asking for and receiving suggestions and comments about the FMB Upright Trailer Storage Stand and making the change to my own trailer stand I would like to suggest the addition of an extra bolt in each receiver bracket. A 5/16 hole should be drilled and a bolt installed 3" closer to the axle from the existing hole. The addition of the one bolt in each bracket will make your stand much more stable. This is only a suggested improvement. Your stand should work pefectly well without these bolts. However, if you plan on sliding your trailer sideways while upright, this will make your stand much more stable. I use a standard 5/16-18 x 3/4" bolt, lock washer and nut.
This message has been edited by Larry Lord on 06-12-2002 at 01:31 AM |
All times are CT (US) Top of Page Previous Page | Return to General Prowler Discussion next newest topic | next oldest topic |
All material contained herein, Copyright 2000 - 2012 ProwlerOnline.com
E-Innovations, LP