Home Page | Owners Registry | Discussion Forums | ProwlerMall | Event Scrapbooks | About |
Click here to return to the Prowler Online Board Main Page Topic Closed |
ProwlerOnline, Plymouth/Chrysler Prowler Discussion Forum
General Prowler Discussion Rear license Plate Bulbs
|
Bottom of Page | next newest topic | next oldest topic |
Author | Topic: Rear license Plate Bulbs |
BOBS 57 POA Site Supporter Prowler Junkie From:Bonita Springs, Florida |
posted 05-11-2001 06:46 PM
Does anyone know the trick to getting these stupid bulbs out of the socket? Bought some of those blue bulbs to try. Took the cover off the bulbs and tried to remove them. There is only a 1/4 inch of the bulb exposed. Tried to remove them without touching them with my fingers so I used a paper towel and tried to grab the bulb and pull it out. Could not get a good grip. Maybe I should try using one of those rubber things you use to open cans and bottles when they are on to tight. I could get a better grip. Was getting dark so I could not mess with for long. Anyone remove these yet? Suggestions anyone? ------------------ |
CJ POA Lifetime Site Supporter Prowler Junkie Personal ScrapBook From:Rochester Hills, MI USA |
posted 05-11-2001 08:18 PM
License Plate Lamp Bulb REMOVAL (1) Remove screws holding the license plate lamp lens to rear bumper
(1) Push bulb into bulb socket ------------------ |
cnote6 POA Site Supporter Prowler Junkie Personal ScrapBook From:Dallas, TX |
posted 05-11-2001 10:42 PM
------------------ |
FatManInTheBathTub Prowler Junkie From:Palm Coast, FL. |
posted 05-12-2001 07:42 AM
Hey now, I used needle nose.............and it don't matter if you touch these.........their not HID or anything, they are reg 194's............ |
BOBS 57 POA Site Supporter Prowler Junkie From:Bonita Springs, Florida |
posted 05-12-2001 10:35 AM
Thanks all, CJ, I have the book as well and looked it up too. It just doesn't say how to pull them out. I was not sure if I would screw up the original if I touched it or not. My lack of car knowledge showing. FMITBT, thanks for that confirmation. ------------------ |
All times are CT (US) Top of Page Previous Page | Return to General Prowler Discussion next newest topic | next oldest topic |
All material contained herein, Copyright 2000 - 2012 ProwlerOnline.com
E-Innovations, LP