 Click here to return to the Prowler Online Board Main Page  Topic Closed
|
 ProwlerOnline, Plymouth/Chrysler Prowler Discussion Forum
 General Prowler Discussion
 Controller Replacement
|
This topic has been transferred to: Prowler Performance/Appearance Discussion |
next newest topic | next oldest topic |
| Author | Topic: Controller Replacement |
Larry Summers  POA Site Supporter Prowler Junkie From:Bonita Springs, Florida USA |
posted 12-17-2007 03:45 PM
    
my new email is larrysummersfl@comcast.net |
Gary C      POA Site Supporter Prowler Junkie Personal ScrapBook From:San Diego Area |
posted 12-17-2007 04:03 PM
quote: |
KOL CAT     POA Site Supporter Prowler Junkie From:Palm Beach Gardens,Florida |
posted 12-18-2007 08:37 AM
Larry, cat fixed. Gene |
Mike Krehel        POA Site Supporter The World's Quickest Prowler (11.65 sec) and Administrating Kat Personal ScrapBook From:United States |
posted 12-18-2007 10:44 AM
It's made by Split Second Performance. Go to their website http://www.splitsec.com/index.html and click on products, then "Fuel / Timing Calibrators". It's the FTC-1. You may want to contact them for an exact part number since the Paxton box may be OEM with a special setup. Good luck and Merry Christmas. ------------------ |
|
Larry Summers POA Site Supporter Prowler Junkie From:Bonita Springs, Florida USA |
posted 12-19-2007 07:56 AM
To Mike Krehel; Thank you for the prompt response; my local Tech is attempting to solve the problem with Dean's Prowler Pro. Dean apparently has good products and is savvy about these type situations; however, I have found him to be extremely slow to respond. At this time, Dean is our first possible solution; however, we will maintain this information you provided as an alternative. Any more ideas? Merry Christmas |
|
waynec Prowler Enthusiast From:Houston, Texas USA |
posted 12-20-2007 10:33 AM
I also have a Paxton 1000 and discovered that the fuel enrichment was two additional injectors placed in the charge plenum near the intake manifold....this is not good! There is no way the fuel will atomize sufficiently to provide every cylinder the correct amount of fuel. So my recent research looks like this is the most promising solution without going to the AEM, MOTEC or TEC3 engine management systems: This allows us to keep our original injector harness which I would like to do for originality purposes. |
|
Larry Summers POA Site Supporter Prowler Junkie From:Bonita Springs, Florida USA |
posted 12-20-2007 12:21 PM
THANKS to waynec for your prompt reply. I have passed this information on to my Tech. |
|
Larry Summers POA Site Supporter Prowler Junkie From:Bonita Springs, Florida USA |
posted 12-25-2007 09:28 AM
After reflection, I conclude that perhaps I was premature and didn't have enough verified facts in hand before declaring that Dean at Prowler Pro's service needs improvement. I hope Dean accepts this posted apology, as I promise henceforth not to be critical of anyone without benefit of all the facts. |
All times are CT (US) Top of Page Previous Page | Return to General Prowler Discussion next newest topic | next oldest topic |
This topic has been transferred to: Prowler Performance/Appearance Discussion | |
  |
|
Contact Us | Prowler Online Homepage
All material contained herein, Copyright 2000 - 2012 ProwlerOnline.com
E-Innovations, LP
