posted 06-14-2002 07:46 PM                  

Just installed the Prowler Intake System 2.2 by Magic Touch Designs.

I was using the regular flat K&N replacement air filter. I noticed a little difference when I changed from the paper filter to it.

But after installing the MTD 2.2, I am wishing I wopuld have went with it a long time ago. Why did I hold out???

Only took about 20 minutes to install. And after starting the engine, you could hear a small difference when just idling... But when I stepped on the gas (while in park), good lord, it jumps up to 5,000 RPMs so much quicker. Then I put it in drive and step on the gas a little bit... Chripped the tires in my driveway... And I was not trying to. LOL Then just driving around town, man, I could tell a big difference.

I am real impressed with Bill's work. The heat sheild is a little flimsy and popped off a few times while installing it, but I noticed if you push a 1/4 inch back off the Filter (So it is not sitting flush at the back), it fits a bit tighter. I guess because the center part of the clamp is on the ring of the filter. I will have to check it to make sure it does not slip off... :-)

Thanks a lot Bill. And the Bypass Kit is easy too, about 2 minutes work... lol

posted 06-18-2002 07:24 PM                  

Bill is MagicTouchDesigns (MTD)

His products carry the Alley Cat Stamp of Approval

------------------


Call 911 - there is a Prowler in my garage....