Home Page | Owners Registry | Discussion Forums | ProwlerMall | Event Scrapbooks | About |
Prowler Products By Gary | Tom Mills - Plymouth Prowler Parts |
| |||||
Want to register? |
If you have previously registered, but forgotten your password, click here.
$115 shipped. ------------------ 1.25 " fit in the rear well, no problem with the wheel studs, but they are a bit to wide, and the tire can rub in the fenders in stock tires. 3/4 would be the perfect set up, but ... cut down the wheel-bolts so much that they fit is not a good option! I was looking for longer wheel-bolts, than the org. 29mm ones, but, for me it was impossible to find some. 1/4 (0.25) inch spacers are ok with org. bolts. -- This message has been edited by condor on 09-16-2009 at 02:27 AM louisoursler What is the thinnest rear wheel spacer that will work( as dictated by the stud length). Where can these spacers be purchased? Has anyone replaced the studs in the rear axle with longer studs as opposed to using the adapter style spacer? thanks BeWare I believe that would be 1 1/4 inch minimum cnote6 Rich is right 1 1/4, We have added 1" before but you will need to shave down the studs for them to fit. I have added the adaptor,s to a least 20 Prowlers. condor ---------
( .. so I can use 3/4inch spacers)
If you order new custom rims ,(8x17 &10x20 or 8x19" & 10x22" ) you have to spend a lot of messure and thinking about the correct backspacing, that the wheel sits right in the fenders.
All material contained herein, Copyright 2000 - 2020